How to install a Quality Vapor recovery hose factory
Although the Quality Vapor recovery hose factory can be compressed and stretched, if it is not installed in the correct position, it will break quickly and reduce the service life. The Quality Vapor recovery hose factory can be installed horizontally, vertically or obliquely. The ideal state is to install vertically. At the same time, it should avoid installation near the wheels. A baffle can be added if necessary.
Generally, the Quality Vapor recovery hose factory can be divided into three lengths: the first is the compression length, that is, the length when the hose is compressed to the limit position; the second is the installation length, which is in the middle of half of the maximum displacement The length of the hose at the position; the third is the stretched length, the length when the hose is stretched to the maximum limit.
When installing the Quality Vapor recovery hose factory, the hose should be in the middle position, which is the so-called installation length. In this installed state, the hose can move in two directions when subjected to axial load, otherwise, if it can only move in one direction, it will affect the strength of the metal hose and reduce its service life.
Through the above introduction and analysis of how to install a Quality Vapor recovery hose factory, hope it helps you.